hello,
finally i get the TDM plot, it was a problem with the old version of WFN software i think.
thank you so much for your help.
best regards.
Rania
I have successfully used Multiwfn 3.7(dev) based on the files you sent to me in ResearchGate to plot the TDM map, all outputted information has attached:
As you can see, Multiwfn works normally. Please carefully compare your output to my output.
Best regards,
Tian
Hello Tian Lu,
please in need help to generate TDM plot.
however, while proceeding the steps:
.fch>18>2, then i found inputfile cannot found, try again!
can you help me please!
thank you for your time.
Rania